Remove Generator Bracket; Remove Exhaust Manifold From Rh Cylinder Head - Toyota 22R-E Service Manual

EG2–60
ENGINE – ENGINE MECHANICAL
(b) Uniformly loosen the eight cylinder head bolts one
side of each cylinder head in several passes, in the
sequence shown, then do the other side as shown.
Remove the eighteen cylinder head bolts and plate
washers.
NOTICE: Head warpage or cracking could result from
removing bolts in incorrect order.
(c) Lift the cylinder head from the dowels on the cylinder
block, and place the two cylinder heads on wooden
blocks on a bench.
If the cylinder head is off, pry between the cylinder
head and cylinder block with a screwdriver.
NOTICE: Be careful not to damage the contact surfaces
of the cylinder head and cylinder block.

38. REMOVE GENERATOR BRACKET

Remove the three bolts and brackets.
39. REMOVE EXHAUST MANIFOLD FROM RH
CYLINDER HEAD
(a) Remove the bolt, nut and exhaust manifold heat in–
sulator.
(b) Remove the six nuts, exhaust manifold and gasket.