Remove No.2 And No.3 Fuel Pipes; Remove No.4 Timing Belt Cover; Remove No.2 Idler Pulley - Toyota 22R-E Service Manual

EG2–56
ENGINE – ENGINE MECHANICAL
19. REMOVE ENGINE WIRE
(a) Disconnect the following:
Knock sensor connector
Cold start injector time switch connector
ECT sensor connector
ECT sender gauge connector
No.1 ECT switch connector
RH ground strap from No.3 camshaft bearing cap
Injector connectors
(b) Remove the two bolts and engine wire.

20. REMOVE NO.2 AND NO.3 FUEL PIPES

(a) Disconnect the vacuum hose from the TVV.
(b) Remove the four union bolts, eight gaskets, No.2 and
No.3 fuel pipes.

21. REMOVE NO.4 TIMING BELT COVER

Remove the four bolts and timing belt cover.

22. REMOVE NO.2 IDLER PULLEY

Remove the four bolts and idler pulley.