Injectors Inspection; Measure Resistance Of Injector - Toyota 22R-E Service Manual

EG2–224
ENGINE – MFI SYSTEM
(b) Remove two bolts and engine wire.
9. REMOVE NO.2 AND NO.3 FUEL PIPES
Remove the four union bolts, No.2, No.3 fuel pipes
and eight gaskets.
10. REMOVE DELIVERY PIPES AND INJECTORS
(a) Remove the four nuts holding the delivery pipes to the
intake manifold.
(b) Remove the the two delivery pipes and six injectors
assemblies.
NOTICE: Be careful not to drop the injectors when rem–
oving the delivery pipes.
(c) Remove the four insulators, ten spacers and four O–
rings from the cylinder head.
(d) Pull out the six injectors from the delivery pipes.
(e) Remove the O–ring and grommet from each injector.

INJECTORS INSPECTION

1. MEASURE RESISTANCE OF INJECTOR

Using an ohmmeter, check the resistance of both
terminals.
Resistance:
13.4–14.2 Ω