Remove Distributor; Remove O–Ring; Check No.1 Cylinder To Tdc/Compression - Toyota 22R-E Service Manual

IGNITION SYSTEM – (3VZ– E)
3. REMOVE DISTRIBUTOR CAP AND DUST PROOF
PACKING
4. SET NO.1 CYLINDER TO TDC/COMPRESSION
(a) Turn the crankshaft pulley until the timing mark is
aligned with the "0" mark on the No.1 timing belt
cover.
(b) Check that the distributor rotor direction is as shown.
If not, turn the crankshaft pulley one complete revo–
lution.

5. REMOVE DISTRIBUTOR

(a) Remove the hold–down bolt.
(b) Pull out the distributor from the cylinder head.
6. REMOVE O–RING
DISTRIBUTOR INSTALLATION

1. CHECK NO.1 CYLINDER TO TDC/COMPRESSION

2. INSTALL DISTRIBUTOR
(a) Install a new O–ring to the distributor.
HINT: Always use a new 0–ring when installing the
distributor.
(b) Align the protrusion on the driven gear with the
groove of the distributor housing.
IG–25