Install Dust Proof Packing And Distributor Cap; Connect High–Tension Cords To Distributor Cap; Connect Distributor Connector - Toyota 22R-E Service Manual

IG–26
IGNITION SYSTEM – (3VZ– E)
(c) Insert the distributor, aligning the groove of the dis–
tributor housing with the groove on the No.4 cam–
shaft bearing cap.
(d) Lightly tighten the hold–down bolt.
3. INSTALL DUST PROOF PACKING AND
DISTRIBUTOR CAP
4. CONNECT HIGH–TENSION CORDS TO
DISTRIBUTOR CAP
(a) Aline the spline of the distributor cap with the spline
groove of the holder, then slide the holder with the
grommet onto the distributor cap.
NOTICE: Check that the holder is correctly installed to
the grommet and distributor cap as shown in the illus–
tration.
(b) Check that the lock claw of the holder is engaged by
lightly pulling the holder.

5. CONNECT DISTRIBUTOR CONNECTOR