Oil Pump Assembly And Installation; Install Drive And Driven Rotors; Install Pump Body Cover; Install Relief Valve - Toyota 22R-E Service Manual

EG2–284
ENGINE – LUBRICATION SYSTEM
OIL PUMP ASSEMBLY
(See components)

1. INSTALL DRIVE AND DRIVEN ROTORS

Put the drive and driven rotors in the pump body.

2. INSTALL PUMP BODY COVER

Install the pump body cover with the seven screws.
Torque: 10 N–m (105 kgf–cm, 8 ft–Ibf)

3. INSTALL RELIEF VALVE

Install relief valve and the spring in the body, and
screw on the relief valve plug with a new gasket.
Torque: 37 N–m (375 kgf–cm, 37 ft–Ibf)
OIL PUMP INSTALLATION
(See components)
1. INSTALL OIL PUMP
(a) Remove any old packing (FIPG) material and be car–
eful not to drop any oil on the contact surfaces of the
oil pump and cylinder block.
Using a razor blade and gasket scraper, remove
all the old packing (FIPG) material from the
gasket surfaces and sealing grooves.
Throughly clean all components to remove all the
loose material.
Using a non–residue solvent, clean both sealing
surfaces.
(b) Apply seal packing to the oil pump as shown in the
illustration.
Seal packing:
Part No. 08826–00080 or equivalent