ENGINE
–
MFI SYSTEM
(i) Disconnect the test probes from the battery and
check fuel leakage from the injector.
Fuel drop: One drop or less per minute
(j) After checking, remove SST and restore the following
parts to their original conditions.
DLC1
Ignition switch
Cold start injector
Injector wiring
COLD START INJECTOR INSTALLATION
1. INSTALL COLD START INJECTOR
(a) Using new gasket, install the cold start injector with
the two bolts.
Torque: 7.8 N–m (80 kgf–cm, 69 in.–Ibf)
(b) Install the fuel pipe between the cold start injector
and fuel delivery pipe with new gaskets.
Torque: 19 N–m (195 kgf–cm, 14 ft–lbf)
2. CONNECT COLD START INJECTOR CONNECTOR
3. CONNECT CABLE TO NEGATIVE TERMINAL OF
BATTERY
4. CHECK FOR FUEL LEAKAGE
EG1–185