ENGINE
–
LUBRICATION SYSTEM
CRANKSHAFT FRONT OIL SEAL
REPLACEMENT
HINT: There are two methods (A and B) to replace the
oil seal which are as follows:
REPLACE CRANKSHAFT FRONT OIL SEAL
A. If oil pump is removed from cylinder block:
(a) Using a screwdriver, pry out the oil seal.
(b) Using SST and a hammer, tap in a new oil seal until its
surface is flush with the oil pump body edge.
SST 09309–37010
(c) Apply MP grease to the oil seal lip.
B. If oil pump is installed to the cylinder block:
(a) Using a knife, cut off the oil seal lip.
(b) Using a screwdriver, pry out the oil seal.
NOTICE: Be careful not to damage the crankshaft. Tape
the screwdriver tip.
(c) Apply MP grease to a new oil seal lip.
(d) Using SST and a hammer, tap in the oil seal until its
surface is flush with the oil pump body edge.
SST 09306–37010
EG2–283