Remove Ps Pump From Bracket; Remove Compressor From Bracket; Disconnect Transfer Shift Linkage - Toyota 22R-E Service Manual

EG1–48
ENGINE – ENGINE MECHANICAL
(c) (w/Cruise control)
Cruise control cable
14. (w/PS)

REMOVE PS PUMP FROM BRACKET

(a) Remove the drive belt.
(b) Remove the four bolts.
(c) Remove the PS pump.
HINT: Lay the PS pump to one side without disconn–
ecting the hoses.
15. DISCONNECT GROUND STRAP FROM PS PUMP
BRACKET
16. (with A/C)

REMOVE COMPRESSOR FROM BRACKET

(a) Loosen the drive belt adjusting bolt and remove the
drive belt.
(6) Remove the compressor on the front side without
disconnecting the hoses.
17. DISCONNECT GROUND STRAPS FROM ENGINE
REAR SIDE AND RH SIDE
18. (M/T)
REMOVE SHIFT LEVER(S) FROM INSIDE OF VEHI–
CLE
19. REMOVE REAR PROPELLER SHAFT
(See PR section)
20. (2WD A/T)
DISCONNECT MANUAL SHIFT LINKAGE FROM
PNP SWITCH
21. (4WD A/T)

DISCONNECT TRANSFER SHIFT LINKAGE

(a) Disconnect the No.1 and No.2 transfer shift linkages
from the cross shaft.