Cylinder Heads Installation; Install Rh Exhaust Manifold To Rh & Lh Cylinder Head; Install Generator Bracket; Install Cylinder Heads - Toyota 22R-E Service Manual

EG2–76
ENGINE – ENGINE MECHANICAL

CYLINDER HEADS INSTALLATION

(See Components)
1. INSTALL RH EXHAUST MANIFOLD TO RH
CYLINDER HEAD
(a) Install a new gasket and the exhaust manifold with the
six nuts.
Torque: 38 N–m (400 kgf–cm, 29 ft–lbf)
(b) Install the exhaust manifold heat insulator with the
bolt and nut.
2. INSTALL RH EXHAUST MANIFOLD TO LH
CYLINDER HEAD
(a) Install a new gasket and the exhaust manifold with the
six nuts.
Torque: 39 N–m (400 kgf–cm, 29 ft–lbf)
(b) Install the exhaust manifold heat insulator with the
three bolts.

3. INSTALL GENERATOR BRACKET

Install the bracket with the three bolts.
Torque: 37 N–m (38o kgf–cm, 27 ft–!bf)

4. INSTALL CYLINDER HEADS

A. Place cylinder head on cylinder block
(a) Place two new cylinder head gaskets in position on
the cylinder block.
NOTICE: Be careful of the installation direction.
(b) Place the two cylinder heads in position on the cyl–
inder head gasket.