Setting The Delay For Disconnecting A Backup Link; Setting The Warm-Up Timer For Dynamic Route Backup; Disconnecting A Dialup Link - HP MSR Router Series Wan Access Configuration Manual

Step
1. Enter system view.
2. Enter the view of the backup
interface.
3. Assign a dialup interface to a
dynamic route backup group

Setting the delay for disconnecting a backup link

Typically, the backup link will be torn down when the primary link recovers. To ensure route stability, set
the delay for disconnecting a backup link.
To set the delay for disconnecting a backup link:
Step
1. Enter system view.
2. Enter the view of the backup
interface.
3. Set the delay for
disconnecting a backup link.

Setting the warm-up timer for dynamic route backup

Typically, after a system reboot, configuration recovery is performed. During the recovery, the primary
interface in a dynamic route backup group is down and the routes on the primary interface are
unavailable. As a result, the backup link is dialed when configuration recovery is being performed. After
the configuration recovers, the primary interface goes up, and the routes on it become available. The
backup link, if dialed up successfully, will be brought down shortly after it went up.
To avoid this problem, set the warm-up timer for dynamic route backup to disable the system from dialing
a backup link within a period of time after a reboot.
To set the warm-up timer for dynamic route backup:
Step
1. Enter system view.
2. Set the warm-up time for
dynamic route backup.

Disconnecting a dialup link

Execute the dialer disconnect command in any view to disconnect a dialup link.
Command
system-view
interface interface-type
interface-number
standby routing-group
group-number
Command
system-view
interface interface-type
interface-number
standby timer routing-disable
delay
Command
system-view
dialer timer warmup delay
192
Remarks
N/A
N/A
By default, a dialup interface is not
assigned to any dynamic route
backup groups.
Remarks
N/A
N/A
The default setting is 20 seconds.
Remarks
N/A
The default setting is 30 seconds.
Use the default setting in normal
cases.