Enable Telnet - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
disable clipaging
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To disable pausing of the screen display when show command output reaches the end of the page:
DGS-3620-28PC:admin#disable clipaging
Command: disable clipaging
Success.
DGS-3620-28PC:admin#
2-16

enable telnet

Description
This command is used to enable Telnet and configure a port number. The default setting is
enabled and the port number is 23.
Format
enable telnet {<tcp_port_number 1-65535>}
Parameters
<tcp_port_number 1-65535> - (Optional) Specifies the TCP port number. TCP ports are
numbered between 1 and 65535. The "well-known" TCP port for the Telnet protocol is 23.
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable Telnet and configure a port number:
DGS-3620-28PC:admin#enable telnet 23
Command: enable telnet 23
Success.
DGS-3620-28PC:admin#
21