Policy Config; Policy Summary - TP-Link T1700X-16TS User Manual

S-Port:
D-Port:
Time-Range:
Note:
Before binding an IPv6 ACL to an interface or VLAN, you should configure the SDM template as
"enterpriseV6" and save your configurations. See
template configuration.

11.2 Policy Config

A Policy is used to control the data packets those match the corresponding ACL rules by
configuring ACLs and actions together for effect.
The Policy Config can be implemented on Policy Summary, Police Create and Action Create
pages.

11.2.1 Policy Summary

On this page, you can view the ACL and the corresponding operations in the policy.
Choose the menu ACL→Policy Config→Policy Summary to load the following page.
The following entries are displayed on this screen:
Search Option

Select Policy:
Action Table

Select:
Enter the destination IPv6 address contained in the rule, you can
D-IP:
input all the 128 bits, but only upper 64 bits are verified.
Enter IP address mask. If it is set to 1, the upper 64 bits in the
Mask:
destination address of the packet must strictly match the D-IP you
configured. This field is 64-bit long.
Configure L4 source port contained in the rule when TCP/UDP is
defined.
Configure L4 destination port contained in the rule when TCP/UDP is
defined.
Select the time-range for the rule to take effect.
Figure 11-7 Policy Summary
Select name of the desired policy for view. If you want to delete the
desired policy, please click the Delete button.
Select the desired entry to delete the corresponding policy.
178
for more information about SDM
SDM Template