Snmp Group - TP-Link T1700X-16TS User Manual

13.1.3 SNMP Group

On this page, you can configure SNMP Group to control the network access by providing the users
in various groups with different management rights via the Read View, Write View and Notify View.
Choose the menu SNMP→SNMP Config→SNMP Group to load the following page.
The following entries are displayed on this screen:
Group Config

Group Name:
Security Model:
Security Level:
Figure 13-5 SNMP Group
Enter the SNMP Group name. The Group Name, Security Model
and Security Level compose the identifier of the SNMP Group. The
Groups with these three items the same are considered to be the
same.
Select the Security Model for the SNMP Group.
 v1: SNMPv1 is defined for the group. In this model, the
Community Name is used for authentication. SNMP v1 can be
configured on the SNMP Community page directly.
 v2c: SNMPv2c is defined for the group. In this model, the
Community Name is used for authentication. SNMP v2c can be
configured on the SNMP Community page directly.
v3: SNMPv3 is defined for the group. In this model, the USM

mechanism is used for authentication. If SNMPv3 is enabled,
the Security Level field is enabled for configuration.
Select the Security Level for the SNMP v3 Group.
 noAuthNoPriv: No authentication and no privacy security level
is used.
 authNoPriv: Only the authentication security level is used.
 authPriv: Both the authentication and the privacy security levels
are used.
228