Subnet Mask:
Admin Status:
Interface Name:
Interface List
Select :
ID:
Mode:
IP Address:
Subnet Mask:
Interface Name:
Status:
Operation:
For IPv4 interface
Click Edit to display the following figure:
Specify the subnet mask of the interface's IP address.
Specify interface administrator status. Choose Disable to disable
the interface's Layer 3 capabilities.
Specify the name of the network interface.
Select the interfaces to modify or delete.
Displays the ID of the interface.
Display IP address allocation mode.
None: without ip.
Static: setup manually.
DHCP: allocated through DHCP.
BOOTP: allocated through BOOTP.
Displays the IP address of the interface.
Displays the subnet mask of the interface.
Displays the name of the interface.
Displays interface current working status. Working status is up
when admin status is enabled, line protocol is up and IP Address
is set.
You can configure the interface by clicking the Edit/ Edit IPv6, or
check Detail information by clicking Detail.
Figure 9-2 IPv4 Interface Config
143