TP-Link T1700X-16TS User Manual page 189

Choose the menu ACL→ACL Config→IPv6 ACL to load the following page.
The following entries are displayed on this screen:
Create IPv6 Rule

ACL ID:
Rule ID:
Operation:
DSCP:
Flow Label:
IPv6 Source IP:
IPv6 Destination IP:
Figure 11-6 IPv6 ACL Config
Select the desired IPv6 ACL for configuration.
Enter the rule ID.
Select the operation for the switch to process packets which match the
rules.
Permit: Forward packets.

Deny: Discard Packets.

Enter the DSCP information contained in the rule.
Enter the Flow Label information contained in the rule.
Click to enable the IPv6 source IP verification.
Enter the source IPv6 address contained in the rule, you can
S-IP:
input all the 128 bits, but only upper 64 bits are verified.
Enter IP address mask. If it is set to 1, the upper 64 bits in the
Mask:
source address of the packet must strictly match the S-IP you
configured. This field is 64-bit long.
Click to enable the IPv6 destination IP verification.
177