TP-Link T1700X-16TS User Manual page 246

On this page, you can configure the notification function of SNMP.
Choose the menu SNMP→Notification→Notification Config to load the following page.
The following entries are displayed on this screen:
Host Config

IP Address:
User:
Security Model:
Type:
Retry:
Timeout:
UDP Port:
IP Mode:
Security Level:
Notification Table

Select:
IP Address:
IP Mode:
UDP Port:
Figure 13-8 Notification Config
Enter the IP Address of the management Host.
Enter the User name of the management station.
Select the Security Model of the management station.
Select the type for the notifications.
Trap: Indicates traps are sent.
Inform: Indicates informs are sent. The Inform type has a
higher security than the Trap type.
Specify the amount of times the switch resends an inform
request. The switch will resend the inform request if it doesn't
get the response from the management station during the
Timeout interval, and it will terminate resending the inform
request if the resending times reach the specified Retry times.
Specify the maximum time for the switch to wait for the
response from the management station before resending a
request.
Enter the number of the UDP port used to send notifications.
The UDP port functions with the IP address for the notification
sending. The default is 162.
Select the IP mode of the IP address.
Select the Security Model of the management station.
Select the desired entry to delete the corresponding
management station.
Displays the IP Address of the management host.
Displays the IP mode of the IP address.
Displays the UDP port used to send notifications.
234