Policy Config - TP-Link TL-SG2424 User Manual

Choose the menu ACL→ACL Config→Extend-IP ACL to load the following page.
The following entries are displayed on this screen:
Create Extend-IP ACL

ACL ID:
Rule ID:
Operation:
S-IP:
D-IP:
Mask:
IP Protocol:
S-Port:
D-Port:

10.2 Policy Config

A Policy is used to control the data packets those match the corresponding ACL rules by
configuring ACLs and actions together for effect.
The Policy Config can be implemented on Policy Summary, Police Create and Action Create
pages.
Figure 10-5 Create Extend-IP Rule
Select the desired Extend-IP ACL for configuration.
Enter the rule ID.
Select the operation for the switch to process packets which match the
rules.
Permit: Forward packets.

Deny: Discard Packets.

Enter the source IP address contained in the rule.
Enter the destination IP address contained in the rule.
Enter IP address mask. If it is set to 1, it must strictly match the
address.
Select IP protocol contained in the rule.
Configure TCP/IP source port contained in the rule when TCP/UDP is
selected from the pull-down list of IP Protocol.
Configure TCP/IP destination port contained in the rule when
TCP/UDP is selected from the pull-down list of IP Protocol.
140