IBM System x3650 M4 BD Type 5466 Installation And Service Manual page 253

Figure 155. Type 1 - SATA
v Type 2 - SAS
– Reconnect the I
Figure 156. Type 2 - SAS
3. Align the backplane with the slot on the rear hard disk drive cage.
4. Lower the backplane into the rear hard disk drive cage. Make sure the three
alignment pins securely engages the three holes on the hard disk drive cage.
Figure 157. Backplane installation
5. For information on how to connect the relevant cabling on the backplane to the
server, please refer to "Replacing the hot-swap rear hard disk drive cage" on
page 171.
6. Install the hot-swap hard disk drives in the rear hard disk drive cage (see
"Replacing a hot-swap hard disk drive" on page 167.
2
C signal, SAS signal and power cables.
Chapter 6. Removing and replacing components
237