Removing A Usb Embedded Hypervisor Flash Device - IBM System x3650 M4 BD Type 5466 Installation And Service Manual

Removing a USB embedded hypervisor flash device

Use this information to remove a USB embedded hypervisor flash device.
About this task
To remove a USB hypervisor key from the server, complete the following steps:
Procedure
1. Read the safety information that begins on page "Safety" on page vii and
2. Turn off the server (see "Turning off the server" on page 22) and all attached
3. Remove the server top cover (see "Removing the server top cover" on page
4. Rotate the hot-swap rear hard disk drive cage up (see "Rotating the hot-swap
5. Remove PCI riser-card assembly 1 (see "Removing a PCI riser-card assembly"
6. Locate the USB embedded hypervisor flash device connector on the system
Figure 110. USB embedded hypervisor flash device connector
7. Slide the lockbar on the flash device connector to the unlocked position and
198
System x3650 M4 BD Type 5466: Installation and Service Guide
"Installation guidelines" on page 32.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
258).
rear hard disk drive cage up" on page 168.
on page 206).
board.
pull the USB flash device out of the connector.