Replacing The Hot-Swap Rear Hard Disk Drive Cage - IBM System x3650 M4 BD Type 5466 Installation And Service Manual

Figure 82. Hot-swap rear hard disk drive cage removal
5. Rotate the rear hard disk drive cage outwards▌2▐.
6. Make sure the switch on the rear hard disk drive cage is in the unlock position.
7. Carefully pull the rear hard disk drive cage ▌3▐ out of the chassis.
8. If you are instructed to return the rear hard disk drive cage, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.

Replacing the hot-swap rear hard disk drive cage

Use this information to replace the hot-swap rear hard disk drive cage.
About this task
To install the rear hot-swap hard disk drive cage, complete the following steps:
Procedure
1. Read the safety information that begins on page "Safety" on page viiand
"Installation guidelines" on page 32.
2. Turn off the server (see "Turning off the server" on page 22) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
3. Remove the server top cover (see "Removing the server top cover" on page
258.
4. Open the two respective blue latches on the chassis ▌1▐.
5. Align the two moveable levers of the rear hard disk drive cage with the two
chassis support brackets. Slide the cage into the chassis support brackets until
it firmly sits into place ▌2▐.
Chapter 6. Removing and replacing components
171