Figure 140. Lower power supply card installation
4. Reconnect the cables between the upper power supply card and lower
power-supply paddle card.
5. Align the screw holes on the safety cover (240VA cover) with the screw holes
on the chassis; then install the screws to secure the safety cover.
Figure 141. Screws installation
6. Reconnect any cables that were removed from the lower power-supply paddle
card.
7. Reconnect the lower power-supply paddle card cables to the system board.
You can refer to the internal cable routing section "Internal cable routing" on
page 164 for further details.
Chapter 6. Removing and replacing components
227