IBM System x3650 M4 BD Type 5466 Installation And Service Manual page 94

Figure 64. USB embedded hypervisor flash device installation
8. Align the USB flash device with the connector on the system board and push it
9. Slide the lockbar toward the riser-card assembly to the locked position until it
Results
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 79.
Note: You must configure the server to boot from the hypervisor USB drive. See
"Configuring the server" on page 88 for information about enabling the embedded
hypervisor.
78
System x3650 M4 BD Type 5466: Installation and Service Guide
into the connector until it is firmly seated.
is seated firmly.