4. Connect cables to the backplane.
v Type 1 - SATA
– Connect the LED signal, SATA signal and power cables to the backplane.
Figure 41. Type 1 - SATA
v Type 2 - SAS
2
– Connect the I
C signal, SAS signal and power cables to the backplane.
Figure 42. Type 2 - SAS
5. Align the backplane with the slot on the rear hard disk drive cage.
6. Lower the backplane into the rear hard disk drive cage. Make sure the three
alignment pins securely engages the three holes on the hard disk drive cage.
Figure 43. Hot-swap backplane installation
Chapter 2. Installing optional devices
57