Turning Off The Server - IBM System x3650 M4 BD Type 5466 Installation And Service Manual

configuration of the server, and the configured PCI options.

Turning off the server

Use this information to turn off the server.
When you turn off the server and leave it connected to power, the server can
respond to requests from the IMM2, such as a remote request to turn on the server.
While the server remains connected to power, one or more fans might continue to
run. To remove all power from the server, you must disconnect it from the power
source.
Some operating systems require an orderly shutdown before you turn off the
server. See your operating-system documentation for information about shutting
down the operating system.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current from
the device, ensure that all power cords are disconnected from the power source.
The server can be turned off in any of the following ways:
v You can turn off the server from the operating system, if your operating system
v You can press the power-control button to start an orderly shutdown of the
v If the operating system stops functioning, you can press and hold the
v The IMM2 can turn off the server as an automatic response to a critical system
v You can turn off the server through a request from the IMM2.
22
System x3650 M4 BD Type 5466: Installation and Service Guide
supports this feature. After an orderly shutdown of the operating system, the
server will be turned off automatically.
operating system and turn off the server, if your operating system supports this
feature.
power-control button for more than 4 seconds to turn off the server.
failure.