Table of Contents
Advertisement
Figure 26. Adapter removal
8. Place the adapter on a flat, static-protective surface.
9. If you are instructed to return the adapter, follow all packaging instructions,
Results
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 79.
Removing a ServeRAID adapter from the PCI riser-card
assembly
Use this information to remove a ServeRAID adapter from the PCI riser-card
assembly.
About this task
To remove a ServeRAID adapter from the PCI riser-card assembly, complete the
following steps:
Procedure
1. Read the safety information that begins on page "Safety" on page vii and
2. Turn off the server (see "Turning off the server" on page 22) and all attached
3. Remove the server cover (see "Removing the server top cover" on page 258).
4. Rotate the hot-swap rear hard disk drive cage up (see "Rotating the hot-swap
42
System x3650 M4 BD Type 5466: Installation and Service Guide
and use any packaging materials for shipping that are supplied to you.
"Installation guidelines" on page 32.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
rear hard disk drive cage up" on page 36.
Advertisement
Table of Contents
Troubleshooting
