Removing A Memory Module - IBM System x3650 M4 BD Type 5466 Installation And Service Manual

Figure 97. Rear fan installation
3. Lower the fan into the fan slot in the server and ensure that is it seated
4. Connect the system fan cable to the connector on the system board. (see
5. Install the server top cover (see "Replacing the server top cover" on page 260).
6. Reconnect the external cables; then, reconnect the power cords and turn on the

Removing a memory module

Use this information to remove a memory module.
About this task
To remove a dual inline memory module (DIMM), complete the following steps:
Procedure
1. Read the safety information that begins on page "Safety" on page vii and
2. Turn off the server (see "Turning off the server" on page 22) and all attached
3. Remove the server top cover (see "Removing the server top cover" on page
4. Rotate the hot-swap rear hard disk drive cage up (see "Rotating the hot-swap
5. Remove the PCI riser-card assembly (see "Removing a PCI riser-card assembly"
6. Remove the air baffle (see "Removing the air baffle" on page 261).
7. Carefully flip open the retaining clip on each end of the DIMM connector and
186
System x3650 M4 BD Type 5466: Installation and Service Guide
correctly.
"System-board internal connectors" on page 26)
peripheral devices and the server.
"Installation guidelines" on page 32.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
258).
rear hard disk drive cage up" on page 168).
on page 206).
lift the DIMM from the connector.
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, open and close the clips gently.