IBM System x3650 M4 BD Type 5466 Installation And Service Manual page 335

4000008a-00000000 Management Controller [arg1]: Configuration restoration from a file by user [arg2] failed to
start.
Explanation: This message is for the use case where a user restores a Management Controller configuration from a
file and the restoration fails to start.
May also be shown as 4000008a00000000 or 0x4000008a00000000
Severity: Error
Alert Category: System - Other
Serviceable: No
CIM Information: Prefix: IMM and ID: 0138
SNMP Trap ID: 22
Automatically notify Support: No
User response:
1. Turn off the server and disconnect it from the power source. You must disconnect the server from ac power to
reset the IMM.
2. After 45 seconds, reconnect the server to the power source and turn on the server.
3. Retry the operation.
4000008b-00000000 One or more of the Storage Management IP addresses has changed.
Explanation: This message is for the use case where an IP address for the Storage Management has changed
May also be shown as 4000008b00000000 or 0x4000008b00000000
Severity: Info
Alert Category: System - IMM Network event
Serviceable: No
CIM Information: Prefix: IMM and ID: 0139
SNMP Trap ID: 37
Automatically notify Support: No
User response: Information only; no action is required.
80010002-0701ffff Numeric sensor [NumericSensorElementName] going low (lower non-critical) has asserted.
(CMOS Battery)
Explanation: This message is for the use case when an implementation has detected a Lower Non-critical sensor
going low has asserted.
May also be shown as 800100020701ffff or 0x800100020701ffff
Severity: Warning
Alert Category: Warning - Voltage
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0476
SNMP Trap ID: 13
Automatically notify Support: No
User response: Replace the system battery.
4000008a-00000000 • 80010002-0701ffff
Appendix A. Integrated management module II (IMM2) error messages
319