Table of Contents
Advertisement
Removing the paddle card safety cover (240VA cover)
Use this information to remove the paddle card safety cover (240VA cover) from
the server.
About this task
To remove the paddle card safety cover, complete the following steps.
Procedure
1. Read the safety information that begins on page "Safety" on page vii and
"Installation guidelines" on page 32.
2. Turn off the server (see "Turning off the server" on page 22) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
3. Remove the server top cover (see "Removing the server top cover" on page
258).
4. Remove the screws that secure the safety cover to the chassis and remove the
safety cover.
Figure 191. Screws removal
5. If you are instructed to return the air baffle, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Chapter 6. Removing and replacing components
263
Advertisement
Table of Contents
Troubleshooting
