Table of Contents
Advertisement
W.3048006
[W.3048006] UEFI has booted from the backup flash bank due to an Automatic Boot Recovery (ABR)
event.
Explanation: Automated Boot Recovery, Booting Backup UEFI Image
Severity: Warning
User response: Complete the following steps:
1.
Check IBM support site for an applicable service bulletin or firmware update that applies to this error.
2.
Reflash Primary UEFI image. Refer to UEFI Recovery section of service information for this product.
3.
(Trained service technician only) Replace the system board.
W.305000A
[W.305000A] An invalid date and time have been detected.
Explanation: RTC Date and Time Incorrect
Severity: Warning
User response: Complete the following steps:
1.
Check IMM/chassis event log. This event should immediately precede 0068002 error. Service that event or any
other battery related errors.
2.
Use F1 Setup to reset date and time. If problem returns after a system reset, replace CMOS battery.
3.
If problem persists then check IBM support site for an applicable service bulletin or firmware update that applies
to this error.
4.
Trained Service technician only) Replace the system board.
W.3058009
[W.3058009] DRIVER HEALTH PROTOCOL: Missing Configuraiton. Requires Change Settings From
F1.
Explanation: DRIVER HEALTH PROTOCOL: Missing Configuration. Requires Change Settings From F1
Severity: Warning
User response: Complete the following steps:
1.
Go to System Settings > Settings > Driver Health Status List and find a driver/controller reporting Configuration
Required status.
2.
Search for the driver menu from System Settings and change settings appropriately.
3.
Save settings and restart system.
W.305800A
[W.305800A] DRIVER HEALTH PROTOCOL: Reports 'Failed' Status Controller.
Explanation: DRIVER HEALTH PROTOCOL: Reports 'Failed' Status Controller
Severity: Warning
User response: Complete the following steps:
1.
Reboot the system.
2.
If problem persists, switch to backup UEFI or reflash current UEFI image.
3.
(Trained Service Technician Only) Replace system board.
W.3048006 • W.305800A
Appendix B. UEFI/POST error codes
605
Advertisement
Table of Contents
Troubleshooting
