Replacing The Server Top Cover - IBM System x3650 M4 BD Type 5466 Installation And Service Manual

Replacing the server top cover

Use this information to replace the server top cover.
About this task
To install the server top cover, complete the following steps:
Procedure
1. Make sure that all cables, adapters, and other components are installed and
2. Align the cover over the server (toward the rear of the server) until the cover
3. Slide the cover forward toward the front of the server until the cover is
4. Tighten the thumbscrews on the rear of the cover to secure the cover to the
Figure 188. Cover installation
5. Install the server into the rack enclosure and tighten the two front thumbscrews
6. Reconnect the external cables; then, reconnect the power cords and turn on the
260
System x3650 M4 BD Type 5466: Installation and Service Guide
seated correctly and that you have not left loose tools or parts inside the server.
Also, make sure that all internal cables are correctly routed.
edges slip into position over the chassis.
Attention: Before sliding the cover forward, make sure that all the tabs on
both the front, rear, and side of the cover engage the chassis correctly. If all the
tabs do not engage the chassis correctly, it will be hard to remove the server
top cover in the future.
completely closed.
chassis.
to secure the server in the rack.
Attention: Two or more people are required to install the system in a rack
cabinet.
peripheral devices and the server.