IBM System x3650 M4 BD Type 5466 Installation And Service Manual page 408

806f011b-0701ffff • 806f0125-0b01ffff
806f011b-0701ffff The connector [PhysicalConnectorElementName] has encountered a configuration error. (Front
USB)
Explanation: This message is for the use case when an implementation has detected an Interconnect Configuration
Error.
May also be shown as 806f011b0701ffff or 0x806f011b0701ffff
Severity: Error
Alert Category: Critical - Other
Serviceable: Yes
CIM Information: Prefix: PLAT and ID: 0266
SNMP Trap ID: 50
Automatically notify Support: Yes
User response: If the specified sensor is front USB connector, reset the front USB cable on the system board. If the
specified sensor is PwrPaddle cable, complete the following steps until problem is solved:
1. Reseat the power paddle cable on the system board.
2. Replace the power paddle cable.
3. (Trained technician only) Replace the supercap n. (n = supercap number)
4. (Trained technician only) Replace the system board.
806f0123-2101ffff Reboot of system [ComputerSystemElementName] initiated by [WatchdogElementName].
(IPMI Watchdog)
Explanation: This message is for the use case when an implementation has detected a Reboot by a Watchdog
occurred.
May also be shown as 806f01232101ffff or 0x806f01232101ffff
Severity: Info
Alert Category: System - Other
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0370
SNMP Trap ID:
Automatically notify Support: No
User response: No action; information only.
806f0125-0b01ffff [ManagedElementName] detected as absent. (PCI Riser 1)
Explanation: This message is for the use case when an implementation has detected a Managed Element is Absent.
May also be shown as 806f01250b01ffff or 0x806f01250b01ffff
Severity: Info
Alert Category: System - Other
Serviceable: No
CIM Information: Prefix: PLAT and ID: 0392
SNMP Trap ID:
Automatically notify Support: No
User response: Please ensure the PCI riser 1 has been installed correctly.
392
System x3650 M4 BD Type 5466: Installation and Service Guide