Outputs; Outputs For Tripping, Controlling And Signalling - ABB REG650 Technical Manual

1MRK 502 034-UEN -
17.3
17.3.1
Technical Manual
Terminal Description
X339-8 Common - for inputs 4-5
X339-9 Binary input 4 +
X339-10 Binary input 5 +
X339-11 -
X339-12 Common - for inputs 6-7
X339-13 Binary input 6 +
X339-14 Binary input 7 +
X339-15 -
X339-16 Common - for inputs 8-9
X339-17 Binary input 8 +
X339-18 Binary input 9 +

Outputs

Outputs for tripping, controlling and signalling

Output contacts PO1, PO2 and PO3 are power output contacts used, for example,
for controlling circuit breakers.
Each signal connector terminal is connected with one 0.5...2.5 mm
2
two 0.5...1.0 mm wires.
The connected DC voltage to outputs with trip circuit supervision
(TCS) must have correct polarity or the trip circuit supervision
TCSSCBR function will not operate properly.
Table 449: Output contacts X307, 6U half 19"
Terminal Description
Power output 1, normally open
(TCS)
X307-1 -
X307-2 +
Power output 2, normally open
(TCS)
X307-3 -
X307-4 +
Power output 3, normally open
(TCS)
Table continues on next page
Section 17
IED physical connections
PCM600 info
Hardware module
Hardware channel
instance
BIO_6 BI4
BIO_6 BI5
BIO_6 BI6
BIO_6 BI7
BIO_6 BI8
BIO_6 BI9
2
wire or with
PCM600 info
Hardware module Hardware channel
instance
PSM_102 BO1_PO_TCS
PSM_102 BO2_PO_TCS
525