Binary Inputs/Outputs - ABB REB500 Operation Manual

1MRK 500 124-UEN
3.6.3
3.6.3.1
3.6.3.2
Operation Manual
Distributed busbar protection REB500

Binary inputs/outputs

Overview
Figure 25 Configuration / Binary module - Overview
The overview tab shows a list with all
inputs/outputs. See Table 8 for an explanation of the columns.
Table 8 Binary inputs/outputs overview columns
Column Description
ABB ref. Internal designation for the bay or central unit
Feeder in which the bay unit is located, user's label for the bay
Device IED device label
Module IED device type
For further information about the input or output configuration refer to 3.6.3.2 or
3.6.3.5.
Inputs
This tab contains another two sub tabs "Overview" and "Details". The additional
buttons "New signal", "Delete" and "OC event config" are enabled when the
"Overview" tab is active. When the "Details" tab is active only the "New signal"
button is enabled.
configured devices providing binary
Section 3
HMI500
37