Table of Contents
Advertisement
2.1 Preparing The 7530 For Operation
Typically, 7530 hand-helds are configured at the factory and arrive ready for use.
Although the 7530 is equipped with an internal Compact Flash and SD I/O slot,
these slots are not intended for user modification. If a device needs to be changed or
added in these slots, contact qualified Psion Teklogix personnel. Refer to
Appendix A: Support Services And Worldwide Offices for the service number
closest to you.
2.1.1 Equipment You Need To Get Started
You'll need:
•
A 7530 compatible battery charger, docking station or portable docking
module (PDM) with power supply.
•
An operating wireless network (if you are not operating the equipment in
batch mode).
•
A medium Phillips head screwdriver.
2.1.2 Charging The Battery
Important:
The 7530 uses a high capacity Lithium-Ion battery. It is critical
that you review the battery safety guidelines in "Lithium-Ion
Battery Safety Precautions" on page 252 before charging the
battery.
Batteries shipped from the factory are not charged. They must be fully charged prior
to use. Full capacity may not be reached until at least 5 full charge/discharge cycles
have been performed.
7530 batteries can be charged using a gang charger or the 7535 internal charger.
When using the internal charger, a suitable power source is required. All chargers
and docking stations are described in Chapter 7: Peripheral Devices & Accessories
beginning on page 254.
2.1.3 Attaching Carrying Accessories
Psion Teklogix recommends that a carrying accessory – a hand strap, pistol grip or
shoulder strap – be installed on the 7530 before use.
If your hand-held is not fitted with a hand strap or pistol grip, you can install either
using the carrying accessory kit supplied. You'll need:
•
A Phillips head screwdriver.
Preparing The 7530 For Operation
Psion Teklogix 7530 Hand-Held Computer User Manual
Chapter 2: Basic Checkout
13
Advertisement
Table of Contents
Troubleshooting
