Running The Ping Test; Running The Arp Test - AudioCodes MP-26 series User Manual

20.1.1 Running the Ping Test

The procedure below describes how to run a ping (ICMP) test in the 'Diagnostics' screen.
This test is done under the Ping (ICMP Echo) group.

To run a ping test:
1. In the 'Destination' field, enter the IP address or URL to be tested.
2. In the 'Number of pings' field, enter the number of pings you want to perform.
3. Click Go; after a few seconds, diagnostic statistics are displayed. If no new
information is displayed, click the Refresh button.

20.1.2 Running the ARP Test

The ARP test is used to query the physical address (i.e., MAC) of a host.
The procedure below describes how to run an Address Resolution Protocol (ARP) test in
the 'Diagnostics' screen. This test is done under the ARP group.

To run an ARP test:
1. in the 'Destination' field, enter the IP address of the target host.
2. Click Go; after a few moments, diagnostic statistics is displayed. If no new information
is displayed, click Refresh.
User's Manual
Figure 20-2: Running a Ping Test
Figure 20-3: Running an ARP Test
372
MP-26x/MP-27x Multimedia Home Gateway
Document #: LTRT-23510