Registering The Handset To Base Unit - AudioCodes MP-26 series User Manual

User's Manual
5. Define the following line settings:
•
User ID: phone number (extension) of the device handset
•
Display Name: String displayed to remote parties as your caller ID
•
Authentication User Name: User name (obtained from your service provider)
used when sending a response to Unauthorized or Proxy Authentication
Requested (401/407)
•
Authentication Password: Password (obtained from your service provider)
used when sending a response to Unauthorized or Proxy Authentication
Requested (401/407)
24.6

Registering the Handset to Base Unit

Before you can use your handset, you need to register it to the base unit. Up to five
handsets can be registered to the base unit. If the handset is not registered to the base
unit, the following is displayed on its screen:

icon flashes

"Out of Range" message appears in idle state

To register the handset to the base:
1. Press the Menu softkey.
2. Press the
press the Select softkey.
3. On the M-264 base unit, press the DECT LED button until (2 – 5 seconds) it starts
flashing green; the base unit enters registration mode. (The registration mode remains
active for 30 seconds, after which the DECT LED stops flashing. Therefore, proceed
to the next step before this interval expires.)
4. Press the
want to register the handset, and then press the Select softkey; the registration
process begins and the "Registering - Waiting" is displayed.
5. When the handset identifies the base, it displays its radio frequency (RF) identification
(each base has a unique RF ID). Click the Accept softkey to confirm (or press the Rej
softkey to cancel registration).
6. On some handsets, you are prompted to enter a PIN code. The default PIN code is
0000 (see Section
If the handset successfully registers to the base, a confirmation tone is heard and the
icon stops flashing. The handset is automatically allocated the next available handset
number. This handset number is displayed on the handset screen in idle mode. The base
unit to which the handset is successfully registered is marked with an asterisk "*" in the
Registration menu (see Section
Version 4.4.0
navigation keys to scroll to the Registration
navigation keys to choose the base unit (i.e., "Base 1") to which you
31.2 on page 445
30.8 on page 440).
407
for defining the PIN code).
24. Getting Started
icon, and then
MP26x/MP27x