AudioCodes MP-26 series User Manual page 38


To cable the device:
1. Connect the device to the Internet. The cabling depends on the Internet connection:
•
xDSL: connect the xDSL port (located on the rear panel and labeled xDSL) to the
telephone socket, using an RJ-11 telephone cable.
•
WAN Ethernet: connect the LAN4/WAN port (located on the rear panel and
labeled LAN 4/WAN) to an external modem, using a CAT-5 Ethernet cable.
Note: Use minimum 26 AWG wire for cabling the xDSL port to the public switched
telephone network (PSTN).
2. Connect the LAN Ethernet ports (labeled LAN 1 - 4) to your LAN computers, using RJ-
45 CAT-5 Ethernet cables.
3. Connect the telephone ports (labeled Phone 1 - 2) to analog telephones, using RJ-11
telephone cables.
4. Connect the device to a standard 110/220 VAC electrical wall outlet, using the
supplied AC/DC power adapter.
When the device is powered on, the Status LED is lit. After initialization completes (about
two minutes), this LED changes from red to green. If no power is received by
the device, press the Power button located on the rear panel to switch it on.
User's Manual
MP-26x/MP-27x Multimedia Home Gateway
38 Document #: LTRT-23510