Mounting The Device; Figure 3-5: Wall Mount Bracket (E.g., Mp-264) - AudioCodes MP-26 series User Manual

User's Manual
3.3

Mounting the Device

You can place the device on a desktop or mount it on a wall. For desktop mounting, the
device provides integrated rubber feet on its base so that it sits firmly on a desktop.
Alternatively, you can hang your device on a wall, using the supplied device wall-mounting
bracket, as described in this section.
Wall mounting consists of the following main procedural stages:

Preparing the mounting screws on the wall

Hanging the mounting bracket on the wall

Attaching the device to the mounting bracket
Before you begin, ensure that you have the following items:

Wall-mounting bracket (supplied)

2 x screws

2 x wall anchors

Screwdriver
Note: When choosing a wall on which to mount the device, consider cable limitations
and wall structure.

To wall-mount the device:
1. Prepare the wall-mounting screws:
a. Drill two holes in the wall according to the wall-mounting bracket dimensions. The
vertical distance between the holes should be 83 mm (3.27 inches).
b. Insert a wall anchor into each hole.
c. Using a screwdriver, drive screws of the appropriate size into the anchors,
leaving approximately 4 mm (0.16 inches) of the screw head jutting out. This
protrusion will allow you to hang the mounting bracket on the screw head.
Version 4.4.0

Figure 3-5: Wall Mount Bracket (e.g., MP-264)

39
3. Hardware Description
MP26x/MP27x