B.3.5 "Show Running-Config" Of 3560_G3 - AudioCodes Mediant 8000 Installation, Operation & Maintenance Manual

Installation & Operation Manual
B.3.5 "show running-config" of 3560_G3
The 3560_G3 output is identical to the 3560_G2 output, with the exception of the
HSRP private IP addresses and the priority for 3560_G3 (default 100).
B.4 HSRP/VRRP Quality Testing
This section describes the quality tests that are recommended to be performed on the
Cisco L3 switch. These tests are used to verify a smooth transition between states.
There are 4 valid states (illustrated below).
The active Media Gateway Ethernet Switch
according to the number of failed links between the Media Gateway Ethernet Switch,
3560_G2 and 3560_G2G3.
On the other hand, the active L3 switch is chosen according to the failed link between
3560_G2 and 3560_G3 and between 3560_G2 and 3560_G1.
In the EMS, the active Ethernet Switch is displayed.
To verify the L3 switch HSRP state, specify the following command:
show standby brief
B.4.1 Test Procedure
For each state, perform the following tests:
1.
Check connectivity with the Media Gateway via the EMS.
2.
Perform SC switch over and switch back.
3.
Perform a call between a Mediant 8000 managed board and another endpoint in
10.7.0.0 / 16 network.
4.
Perform TP switch over
5.
Make sure that voice is heard on this call.
6.
Perform TP switch back.
7.
Make sure that voice is heard on this call.
For each failure, perform the following tests:
8.
Cause a failure
9.
Check the existence of a call.
10.
Close the call, and reestablish it.
11.
Make sure that voice is heard on this new call.
12.
Return the system to the Initial State.
Version 6.6
B. Appendix - Configuring HSRP/VRRP
is chosen by the Media Gateway
899 October 2014