User's Manual
4.
Enable Bluetooth on your mobile device (phone).
5.
Place the mobile device not more than four meters (in line of sight) from the device.
6.
Activate the Bluetooth Discovery process (pairing) by one of the following:
•
On the device, press the Bluetooth button for five seconds until the LED begins
blinking green.
or
•
On the Web interface, click Discoverable; the paired mobile phone name
appears under the Devices group, as shown in the figure below.
Note:
9.10.2 Unpairing a Mobile Device using the Web
The procedure below describes how to unpair a mobile device using the Web.
To unpair a mobile device using the Web:
1.
In the 'Voice Over IP' screen, access the Bluetooth tab; the following screen appears.
Version 4.4.0
Figure 9-25: Device Names Screen
If the Bluetooth LED on the device is off, Bluetooth is disabled and cannot
connect a device to the device.
Figure 9-26: Bluetooth Initial Screen (e.g., MP-264)
9. Configuring VoIP Parameters
125
MP26x/MP27x