Setting Up And Starting The Automatic Dialer - AudioCodes MP-26 series User Manual

8.2.2

Setting up and Starting the Automatic Dialer

The procedure below describes how to setup and start the Automatic Dialer feature.

To setup and start Automatic Dialer:
1. Power off the device.
2. Connect the xDSL or Ethernet cables.
Note: If you are using an xDSL connection, do not connect any cable to the
WAN/LAN4 port. Connecting this port causes the Automatic Dialer to fail.
3. Power on the device; the Automatic Dialer begins its operation and you can view the
progress status by checking the device's LEDs (see Section
Notes:
•
•
User's Manual
If the connection is xDSL, the Automatic Dialer usually connects in the first
iteration (after less than 10 seconds, when configuring manual PVC). In
some cases, the Automatic Dialer may connect in the second iteration (up
to 4 minutes).
If the connection is WAN Ethernet:
- For DHCP, the connection is fast.
- For L2TP, the connection takes up to ~2 minutes.
- For PPPoE, the connection can take up to ~4 minutes.
86
MP-26x/MP-27x Multimedia Home Gateway
3.1.1.2.1
Document #: LTRT-23510
on page 33).