Configuring Sip Signaling Protocol; Figure 4-8: Signaling Protocol; Figure 4-9: Line Settings - AudioCodes MP-26 series User Manual

4.4

Configuring SIP Signaling Protocol

The procedure below describes how to configure the SIP Signaling Protocol.

To configure the SIP Signaling Protocol:
1. Click the 'Voice Over IP' menu in the side menu bar; the 'Voice Over IP' screen
appears.
2. On the 'Signaling Protocol' page, enter the Gateway Name and then enter the Host
Name as shown in the following screen:
3. Click the Line Settings tab; the following screen appears.
User's Manual

Figure 4-8: Signaling Protocol

Figure 4-9: Line Settings

48
MP-26x/MP-27x Multimedia Home Gateway
Document #: LTRT-23510