Copying A Song On The Disk - Rodgers PR-300S Owner's Manual

t
•
{
•
C
(:
•
• •
• •
~
• •
• •
•
• •
, .
• •
• •
• •
• •
(
TRANSPOSE
=
CJ
c::J c::J
0
=
.
.
TRANSPOSE
TRANSPOSE
MIDI
--
c?r Dr;
If you have not saved a new song or saved changes
to an existing song, the PR-300S will ask, "Data
will be erased. Ok?", (asking if you want to save
the song you were working on). If you press
[ENTER], all work done since the last Save will be
lost. If you don't want to lose this work, press
[STOP), save the song and start this procedure
again.
The screen at right should be seen in the display. If
it doesn't, rotate the alpha-dial until it appears.
(4) Select the song you want to copy by rotating the
alpha-dial, then press [ENTER].
(5) Select the number of the song you want to copy
the Source Song to by rotating the alpha-dial.
~~~sa~~~~~~~n~~o:'~~·s~i~~t~~~c~~~f~uo:l~~; ~ ~~~
•
I
f . , ; : ~ : ~ 4.~Ct.. [:;~?~::.t."
:::;e:n' : ::!
I
existing song, you will write over that song w i t h . .
the song you are copying.
The PR-300S will ask if you're sure you want to
save the song.
This is called the "Source Song", or the song you
are copying from.
The PR-300S will say "Please Wait" for a few
seconds, after which time the Play Screen will
return.
(3) Press [ENTER].
(2) Hold [SHIFT] and press [DISK].
(6) Press [ENTER] to save the song. Press [STOP]
to cancel.
(5) Press [ENTER] once you've finished naming the
song.
(1)
Insert the disk you want to copy from into the
PR-300S's disk drive.
Use this procedure to copy a song to a different
disk (or to another song number on the same disk).
To copy a song:
Copying a Song on the Disk
90
L
L