Rodgers PR-300S Owner's Manual page 127

Example 2.
InMIDI
BO 54 ~C
90 40
40
80 40
40
Description
Ponamento Control from E4
Note on E4
Note otTE4
no change
#4 is played Wilh glide from C4 to E4
E4 off
OEffect I depth (Reverh send level)
Status Second Third
SnH SBH vvH
n=MIDI channel number
vv=Reverb send level
:OH (ch.
J -
ch.16)
:OOH - 7FH
(0 -
127)
"'Effect 1 depth messages control the Send Level of lh speci fied channel (part) to the internal Reverb unit.
OEffect3 depth (Chorus send level)
Status Second Third
SnH
6~H
vvH
n=MIDI channel number
vv=Chorus send level
:OH (ch.1 - ch.16)
:OOH - 7FH
(0 -
127)
*Effect3 depth messages control the Send Level of the specitled channel (part) to the internal Chorus unit.
ONRPN MSB/LSB
Status Second Third
BnH 63H mmH
BnH 62H IIH
n=MIDI channel number
mm=MSB of the NRPN
II=LSB of the NRPN
:OH (ch.1 - ch.16)
*Recognized when "Rx.NRPN = ON". "Rx.NRPN" is set
10
OFF by power-on reset or by receiving "Turn General MIDI System On", and it is set
to ON by "GS RESET".
"'The values set by NRPN won't reset by receiving new Program Change messages or Reset All Controllers.
~''''NRPN**
An NRPN (Non Registered Parameter Number) is an expanded control change message.
Each function of an NRPN is described by the individual manufacturer.
To an NRPN. set NRPN number (MSB/LSB) before sending data. Then send data by Data entry message (Control Change 6/38). Then, it is
recommended that you send RPN null (RPN number = 7FHI7FH) to prevent the data from being changed unexpectedly.
You can change the following parameters using NRPN.
NRPN
MSB LSB
OIH 08H
OIH 09H
Data entry
MSB
mmH
mmH
Description
Vibrato rate
relative change on specitled channel
mm: OEH - 40H - 72H (-50 - 0 - +50)
Vibrato depth
rdati ve change on speci tied channel
mm: OEH - 40H - 72H (-50 - 0 - +50)
119