Rodgers PR-300S Owner's Manual page 130

.Pitch bend change
Status Second Third
EnH IIH mmH
n=M 101 channel number
mm.ll=Value
:OH - FH (ch.1 - ch.16)
:00 OOH - 40 OOH - 7F 7FH (-8192 - 0 - +8191)
*Affects the parameter set on "MOD controller function". The default selling is pitch bend.
*Ignored when "Rx.Pitch bend change = OFF".
.Channel Mode Messages
.AII sounds off
Status Second Third
BnH 78H OOH
~
(
*When "reset all controllers" is received. the controller values of a specified channel return to the default values listed below:
*When "All notes off" is received. all notes are turned offin the specified channel. However, sound continues while holdl and/or sostenuto is on.
*When "All sounds off" is received. all sounds on a specified channel turn off immediately.
However, the state of channel messages down note change. You must not use "All sounds off' messages in place of "Note off' messages.
n=MIDI channel number
.Reset all controllers
Status Second Third
BnH 79H OOH
n=MIDI channel number
Controller
Pitch bend change
Polyphonic key pressure
Channel pressure
Modulation
Expression
Holdl
Portamento
Sostenuto
Soft
RPN
NRPN
.AlI notes off
Status Second Third
BnH 7BH DOH
n=MIDI channel number
.OMNIOFF
Status Second Third
BnH 7CH DOH
n=MIDI channel number
:OH - 7H (ch.1 - ch. 16)
:OH - FH (ch.1 - ch.16)
Default value
+/-0 (Center)
o
(off)
o
(off)
o
(off)
127 (maximum)
o
(off)
o
(off)
o
(off)
o
(off)
disabled. 1l1e parameter already set retains its old value.
disabled. The parameter already set retains its old value.
:OH - FH (ch.1 -ch.16)
:OH - FH (ch.1 - ch.16)
L
(
(
L
r
• •
• •
• •
•
(
• •
• •
• •
• •
(
C
(
l.
"'OMNI OFF is only recognized as "all notes ofr. Mode doesn't change.
122