Table of Contents
Advertisement
Punch In/Out Recording
Sometimes, there are a few measures of a part
which you'd like to record again, but you don't want to
re-record the entire part. Punch In/Out Recording
allows you to re-record a specific portion of a part
without affecting the rest of of the sequence.
In Punch In/Out Record, "Punch In" is the point
where recording begins and "Punch Out" is the point
where recording ends.
Enabling Punch In/Out
(1)
Hold [SHIFT] and press [PUNCH IN/OUT].
(2) Rotate the alpha-dial to select "On".
(3) Press [ENTER] to return to the Play Screen.
This turns the Punch In/Out recording mode on. If
Tempo Record or Repeat Play were previously
selected, they will be automatically turned off.
(4)
If
you are going to use a DP-2 pedal to set the
Punch In and Punch Out points (as described
later in this section), plug it into the "PUNCH
IN/OUT" jack on the back of the PR-300S.
Automatic Punch In/Out
This method is called "Automatic Punch
In/Out" because the Punch In and Punch
Out points are set in advance.
(1) Go to the point where Punch In is to occur and
set Marker A.
If necessary, refer to the section on using Markers
for more information.
(2) Go to the point where Punch Out is to occur and
set Marker B.
TRANSPOSE
•
0
A-MARKER-B
~-
•
•
A-MARKER-B
-~
_ _ _ EXT CONTROL
_
STAAT/
PUNCH
STOP
IN/OUT
EXPAESSION
000
71
Hide quick links:
Advertisement
Table of Contents
