Saving A Sequence To Disk - Rodgers PR-300S Owner's Manual

This will send Ihe organ stops and PR-300S sounds
10
the sequencer so that they will be recorded.
Then, the correct organ registration and PR-300S
sounds will be recreated every time the sequence is
played.
(10) Play the song you wish to record.
In the evenl that the song is too long for the PR-
300S to record, the display will read "MEMORY
FULL - PRESS STOP".
(11) When you are finished playing, press General
Cancel [0] on the organ.
(12) Press [STOP] on the PR·300S to stop recording.
The light above the TRACK I button will be green,
indicaling Ihal it is storing the song you just
recorded.
To playback your sequence:
(1) Press [RESET] to return the PR-300S to the
first measure of the sequence.
(2) Press [PLAY] to start playback.
The PR-300S will playback the song you just
recorded. Press [STOP] at any time to stop
playback.
Saving a Sequence to Disk
The sequence you just recorded is stored in the PR-
300S's memory. It can be played back or added at
this time.
However. when you turn the PR-300S off, this
sequence will be erased. For this reason, you can
save sequences
to
3.5" floppy disks. Once a
sequence has been saved to a disk, it can be
31
RESET
--
•
..
Press [RESET] then press
[PLAY] to hear the
sequence you've just
recorded .