Punch In/Out Using The Button Or Pedal - Rodgers PR-300S Owner's Manual

• 0
A-MARKER-B
~-
«
•
C
• •
• •
• •
• •
• •
• •
• •
• •
C
• •
• •
• •
• •
C
t
o
3 )( 4 ______
o
o
0
TRACK
o
•
PLAY
BWD
ImI
•
11III
When you reach the Punch Out point (Marker B),
the PR-300S will stop recording and normal
playback will begin again (the light above the
[REC] button will start flashing red again).
When you reach the Punch In point (Marker A), the
previously recorded information will no longer be
heard and the information you play will be
recorded (you will write over the old information
with the new information you play). The light
above the [REC] button will stay red during this
recording process.
This procedure allows you to select the
Punch In and Punch Out points during the
recording process by pressing the [REC]
button or a DP-2 Pedal.
The previously recorded information will play and
the light above the [REC] button will blink red.
You can play along wi th the previously recorded
information, if you wish, however, nothing you
play at this point will be recorded.
(6) Press the Track button for the track you wish to
re-record.
(5) Press
[REC].
(3) Jump to the Punch In point by pressing Marker
A.
(8) Press [STOP] when you are finished recording.
(7) Press [PLAY].
(4) Press [BWD] a few times to back up a few
measures.
Punch In/Out Using the Button or Pedal
If you want to use a DP-2 Pedal to
determine the Punch In and Punch Out
points, you must connect it as described
earlier in this chapter.
l.,.
l...
•
72