Rodgers PR-300S Owner's Manual page 129

'"Ignored when "Rx.RPN = OFF".
"The values set by an RPN won't be reset by receiving new Program Change messages or Reset All Controllers.
;,':'" RPN" ':":'
An RPN (Registered Parameter Number) is an expanded control change message.
Each function of an RPN is described by the MIDI Standard.
To use RPN. set RPN number (MSB/LSB) before sending data. Then send data by Data entry message (Control Change 6/38). Then it is
recommended to send RPN null (RPN number = 7FHI7FH) to prevent the data from being changed unexpectedly.
You can change the following parameters using RPN:
RPN
MSB LSB
OOH OOH
Data entry
MSB LSB
mmH
Description
Pitch bend sensitivity
mm: OOH - 18H (0 - 24 semi tones)
II: ignored value (value = OOH)
(Up to two octaves)
Default value = 02H (two semitones)
OOH OIH
OOH 02H
7FH 7FH
.Program Change
Status Second
CnH ppH
mmH IIH
mmH ----
Master fine tuning
mm. II: 00 OOH - 40 OOH - 7F 7FH
(-8192 x 100/8192 - 0 - +8191 x 100/8192 cents)
Master coarse tuning
mm: 28H - 40H - 58H (-24 - 0 - +24 semitones)
II: ignored (value = OOH)
RPN null
Return to the disable condition.
The parameter already set retains its value.
mm. II: ignored
n=MIDI channel number :OH - FH (ch. I - ch. 16)
pp=Program Change number :OOH - 7FH (program change 1 - Program Change 128)
':The Tone of voices already ON before program change message is received isn't affected. The Tone will be changed by a new Note-on message
after the program change is received.
"Ignored when "Rx.Program change - OFF".
*In the drum part. Program change messages are ignored when the Bank is set at 129 - 16384 (i.e., the value of the control change number 0 is note
OOH).
• Channel Pressure
Status Second
DnH vvH
n=MIDI channel number
vv=Value
:OH - FH (ch.1 - ch.16)
:OOH - 7FH
(0 -
127)
*Affects the parameter set on "MOD controller function".
The default selling has no effect.
"Ignored when "Rx.Channel pressure = OFF".
121